LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2012 >> 5 Touring >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Cruise Control Switch Inspection [MZR 2.5] >> Standard Deployment Control System
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Standard Deployment Control System

  1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
  2. Disconnect the negative battery cable and wait for 1 min or more  .
  3. Remove the driver-side air bag module. (See DRIVER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION [STANDARD DEPLOYMENT CONTROL SYSTEM] .)
  4. Disconnect the clock spring connector (part wiring harness-side).
  5. Inspect for resistance and continuity between clock spring connector terminals 4D and 4F (part wiring harness-side) using a tester.
    Fig 1: Cruise Control Switch Circuit Diagram (4D And 4F)
    G08150303
    Fig 2: Identifying Cruise Control Switch Connector Terminals (4D And 4F)
    G08150304
    Switch condition Resistance (ohm)
    Cruise OFF switch held at on Continuity
    CANCEL switch held at on 118.8-121.2
    SET (-) switch held at on 297.0-303.0
    SET (+) switch held at on 594.0-606.0
    RESUME switch held at on 1,098.9-1,121.1
    Cruise ON switch held at on 2,088.9-2,131.1
    Neutral 4,266.9-4,353.1
  6. Apply battery positive voltage to clock spring terminal 4O (part wiring harness-side) and terminal 4E (part wiring harness-side) to ground.
    Fig 3: Applying Battery Voltage And Ground To Clock Spring Terminals 4O, 4E
    G08150305
  7. Verify that the LED illuminates.
scientia non olet · About LEMON Manuals