Front Fog Light Switch Inspection

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION .)
Remove the light switch. (See LIGHT SWITCH REMOVAL/INSTALLATION .)
Verify that the continuity between the front fog light switch terminals is as indicated in the table using a circuit tester.
- If not as indicated in the table, replace the light switch.
Fig 1: Identifying Front Fog Light Switch Connector Terminal & Continuity Chart
Courtesy of MAZDA MOTORS CORP.