LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2012 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 584 (Security System And Locks System) >> Rear Door Latch Switch Inspection
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Rear Door Latch Switch Inspection

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fully open the rear door glass.
  2. Disconnect the negative battery cable.
  3. Remove the following parts:
    1. Rear door trim (See REAR DOOR TRIM REMOVAL/INSTALLATION .)
    2. Rear door speaker (See REAR DOOR SPEAKER REMOVAL/INSTALLATION .)
    3. Rear door quarter glass (See REAR DOOR QUARTER GLASS REMOVAL/INSTALLATION .)
    4. Rear door glass (See REAR DOOR GLASS REMOVAL/INSTALLATION .)
    5. Rear door module panel (See REAR DOOR MODULE PANEL REMOVAL/INSTALLATION .)
    6. Rear door latch and lock actuator (See REAR DOOR LATCH AND LOCK ACTUATOR REMOVAL/INSTALLATION .)
  4. Press the latch in using a flathead screwdriver to inspect the latch lever condition.
    Fig 1: Inspecting Latch Lever Condition
    G06200914Courtesy of MAZDA MOTORS CORP.
  5. Verify that the continuity is as indicated in the table.
    Fig 2: Identifying Door Latch Switch Circuits & Connectors
    G06200915Courtesy of MAZDA MOTORS CORP.
    • If not as indicated in the table, replace the rear door latch and lock actuator.
    Fig 3: Door Latch Switch Continuity Table
    G06200930Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals