LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2013 >> 2 Touring, 1.5L Eng VIN Y, Automatic Trans >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Power Systems >> Ignition Switch Removal/Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Ignition Switch Removal/Installation

  1. Disconnect the negative battery cable.
  2. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION ).
  3. Press tabs A in the direction of the arrow (1) shown in the figure and pull the ignition switch in the direction of the arrow (2).
    Fig 1: Removing Ignition Switch
    G09133655Courtesy of MAZDA MOTORS CORP.
  4. Pull the pin in the direction of the arrow shown in the figure and release the lock.
    Fig 2: Releasing Ignition Switch Lock
    G09133656Courtesy of MAZDA MOTORS CORP.
  5. Pull the connector in the direction of the arrow (4) shown in the figure and remove it while pressing tab B in the direction of the arrow (3).
  6. Remove the ignition switch.
  7. Install in the reverse order of removal.
    Fig 3: Removing Ignition Switch Connector
    G09133657Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals