DTC P0602:00: PCM programming error: Notes
DTC DETECTION CONDITION & POSSIBLE CAUSES
| DTC P0602:00 |
PCM programming error |
| DETECTION CONDITION |
- No configuration data in the PCM.
NOTE:
- If the "PCM CONFIGURATION" is successful, the PCM stores the DTC P0602:00 and illuminates the MIL (the system is normal). Clear the DTC P0602:00 using the M-MDS after the "PCM CONFIGURATION".
- The MIL turns off after three drive cycles with no failure (the DTCs remain in PCM).
Diagnostic support note
- This is a continuous monitor (CCM).
- The MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle.
- FREEZE FRAME DATA (Mode 2)/Snapshot data is available.
- The DTC is stored in the PCM memory.
|
| POSSIBLE CAUSE |
- Configuration procedure has not been completed
- PCM malfunction
|