LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2013 >> 2 Touring, 1.5L Eng VIN Y, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic [Engine Control System MZR 1.5] >> DTC P2109:00: TP sensor minimum stop range/performance problem >> Diagnostic Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Procedure

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA (MODE 2V SNAPSHOT DATA HAS BEEN RECORDED 
  • Has the FREEZE FRAME DATA (Mode 2)/snapshot data been recorded?
Yes Go to the next step.
No Record the FREEZE FRAME DATA (Mode 2)/snapshot data on the repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 INSPECT DRIVE-BY-WIRE CONTROL SYSTEM OPERATION 
Yes Repair or replace the malfunctioning part according to the inspection results, then go to Step 6.
No Go to the next step.
4 INSPECT THROTTLE VALVE ACTUATOR 
Yes Replace the throttle body, then go to Step 6.
(See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZR 1.5] ).
No Go to the next step.
5 INSPECT THROTTLE VALVE 
Yes Replace the throttle body, then go to the next step.
(See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZR 1.5] ).
No Go to the next step.
6 VERIFY DTC TROUBLESHOOTING COMPLETED 
Yes Repeat the inspection from Step 1.
If the malfunction recurs, replace the PCM.
(See PCM REMOVAL/INSTALLATION [MZR 1.5] ).
Go to the next step.
No Go to the next step.
7 VERIFY AFTER REPAIR PROCEDURE 
Yes Go to the applicable DTC inspection.
(See DTC TABLE [MZR 1.5] ).
No DTC troubleshooting completed.