Washer Fluid-Level Sensor Inspection

Disconnect the negative battery cable.
Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION .)
Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION .)
Verify that continuity between the washer fluid-level sensor terminals is as indicated in the table.

Fig 1: Inspecting Continuity Between Washer Fluid-Level Sensor Terminals
- If not as specified, replace the washer fluid-level sensor. (See WASHER FLUID-LEVEL SENSOR REMOVAL/INSTALLATION .)
Fig 2: Washer Fluid-Level Sensor Terminals Continuity Chart