DTC P2108:00: Notes

DTC P2108:00	Throttle valve actuator control module performance error
DETECTION CONDITION	If the PCM detects either of the following conditions, the PCM determines that throttle valve actuator control system has a malfunction. TP sensor power supply voltage below 4.4 V TP sensor No. 1 output voltage below 0.20 V or above 4.85 V (DTC P0122:00 or P0123:00) PCM internal circuit for TP sensor No. 1 input circuit malfunction. Diagnostic support note This is a continuous monitor (CCM). The check engine light illuminates if the PCM detects the above malfunction condition during the first drive cycle. FREEZE FRAME DATA (Mode 2)/Snapshot data is available. The DTC is stored in the PCM memory.
FAIL-SAFE FUNCTION	Stops the idle air control. Stops the drive-by-wire control and sets to a throttle valve opening angle necessary for the minimum driveability.
POSSIBLE CAUSE	Throttle body connector or terminals malfunction PCM connector or terminals malfunction TP sensor No. 1 malfunction TP sensor No. 2 malfunction PCM malfunction
SYSTEM WIRING DIAGRAM	-