LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2013 >> CX-5 Touring, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle [Shift Mechanism] >> Not P Position Switch Inspection
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Not P Position Switch Inspection

NOTE:
  • The not P position switch is built into the selector lever component.
  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0] ).
  2. Remove the front console. (See FRONT CONSOLE REMOVAL/INSTALLATION ).
  3. Disconnect the selector lever component connector.
    Fig 1: Identifying Selector Lever Component Connector
    G09075611
  4. Verify that the continuity between selector lever component terminals B and I.
    NOT P POSITION SWITCH SPECIFICATION

    Test condition Continuity
    Selector lever is in the P position. No continuity
    Selector lever is not in the P position. Continuity
    Fig 2: Checking Continuity Between Selector Lever Component Terminals B And I
    G09075612
scientia non olet · About LEMON Manuals