PID/Data Monitor Table [Two-Step Deployment Control System]
WARNING: This page is about a different car, the 2014 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
PID/DATA MONITOR CHART
| PID name (definition) | Unit/Operation | Operation Status (Reference) | |
|---|---|---|---|
| AB_WL (Air bag system warning light status) | Lamp_Off/Lamp_On/Plant_Mode/Unknown |
|
|
| B_SW_P_FLT (Passenger-side buckle switch malfunction status) | O.K./FAULT |
|
|
| OCS_DTC_CLR (Seat weight sensor DTC cleared status) | Starting/Normal End/In Process/OCS Fault | Fault information cleared at seat weight sensor | |
| P_OCS_ST (Seat weight sensor status) | Empty/SMALL/Indeterminate/LARGE | Occupant classification status determined by seat weight sensor | |
| P_WEIGHT (Seat weight sensor measured weight of passenger) | Kg | Display of load (body weight) on passenger-side seat | |
| RES_C_AB_D (Driver-side curtain air bag module resistance nominal) | ohm | Continuous: 0.81-6.42 ohms | |
| RES_C_AB_P (Passenger-side curtain air bag module resistance nominal) | ohm | Continuous: 0.81-6.42 ohms | |
| RES_F_AB1_D (Driver-side air bag module (inflator No. 1) resistance nominal) | ohm | Continuous: 0.99-6.42 ohms | |
| RES_F_AB1_P (Passenger-side air bag module (inflator No. 1) resistance nominal) | ohm | Continuous: 0.81-6.42 ohms | |
| RES_F_AB2_D (Driver-side air bag module (inflator No. 2) resistance nominal) | ohm | Continuous: 0.99-6.42 ohms | |
| RES_F_AB2_P (Passenger-side air bag module (inflator No. 2) resistance nominal) | ohm | Continuous: 0.81-6.42 ohms | |
| RES_PCD_BAR (Poorly connected detector bar terminals resistance nominal (all of SAS control module connectors)) | ohm |
|
|
| RES_S_AB_D (Driver-side side air bag module resistance nominal) | ohm | Continuous: 0.81-9.85 ohms | |
| RES_S_AB_P (Passenger-side side air bag module resistance nominal) | ohm | Continuous: 0.81-9.85 ohms | |
| RES_SB_LP_D (Driver-side lap pre-tensioner seat belt resistance nominal) | ohm | Continuous: 0.81-6.42 ohms | |
| RES_SB_LP_P (Passenger-side lap pre-tensioner seat belt resistance nominal) | ohm | Continuous: 0.81-6.42 ohms | |
| RES_SB_P_D (Driver-side pre-tensioner seat belt resistance nominal) | ohm | Continuous: 0.81-6.42 ohms | |
| RES_SB_P_P (Passenger-side pre-tensioner seat belt resistance nominal) | ohm | Continuous: 0.81-6.42 ohms | |
| SEAT_B_D (Driver-side buckle switch status) | Unbuckled/Buckled |
|
|
| SEAT_B_P (Passenger-side buckle switch status) | Unbuckled/Buckled | Occupant seated in passenger-side front seat: On |
|
| VPWR_IGA (SAS control module power voltage) | V | Ignition switch is at ON: IG1 voltage | |