Secondary Shaft Assembly Note

Set the secondary shaft in a press as shown in the figure.

Fig 1: Setting Secondary Shaft In Press
Set the secondary shaft with the parts from the secondary 1st gear to the gear sleeve as a single unit.
CAUTION:
- If you take your hand off the secondary 1st gear, it will fall off and the assembled parts will come apart. Therefore, until the assembled parts are press-fit to the secondary shaft, lift up and hold the secondary 1st gear so that each part does not come apart.
Fig 2: Setting Secondary Shaft With Parts From Secondary 1st Gear To Gear Sleeve
Set the gear sleeve to the SST.
Using a press, press-fit the parts from the secondary 1st gear to the gear sleeve to the secondary shaft.

Fig 3: Pressing To Fit Parts From Secondary 1st Gear To Gear Sleeve To Secondary Shaft