October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Variable Tumble Control Operation Inspection
- Connect the M-MDS to the DLC-2.
- Access the ECT PID.
- Verify that the ECT PID is below 60°C {140°F}.
- Start the engine.
- Inspect rod operation under the following conditions:
ROD OPERATION
| Accelerator pedal position |
Release |
Depress |
| Shutter valve actuator |
Operate |
Not operate |
- If the rod operation is not specified, inspect as follows:
- Verify that DTC No. P2004, P2006, P2009 or P2010 is not displayed.
- Inspect the variable tumble solenoid valve. (See
VARIABLE TUMBLE SOLENOID VALVE INSPECTION
).
- If the variable tumble solenoid valve is not normal, replace the variable tumble solenoid valve. (See
INTAKE-AIR SYSTEM REMOVAL/INSTALLATION
).
- If the variable tumble solenoid valve is normal, inspect the following: