Rear Door Quarter Glass Removal/Installation: Notes
- Fully lower the rear door glass.
- Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
- Remove the rear door trim. (See REAR DOOR TRIM REMOVAL/INSTALLATION .)
- Remove the service hole cover arrow (1) shown in the figure.CAUTION:
- When removing service hole cover, remove it while gradually stripping the butyl rubber. Otherwise service hole cover may be deformed.
- Partially peel back rear door weather strip.
- Remove screw.
- Remove bolts.
- Partially peel back the rear door glass run channel. (See REAR DOOR GLASS RUN CHANNEL INSTALLATION NOTE .)
- Pull the glass guide in the direction of the arrow (2) shown in the figure, then remove the glass guide direction of the arrow (3) shown in the figure. (See GLASS GUIDE INSTALLATION NOTE .)
- Pull the rear door glass run channel in the direction of the arrow (4) then remove the rear door glass run channel. (See REAR DOOR GLASS RUN CHANNEL INSTALLATION NOTE .)
- Slide the rear door quarter glass and rear door quarter glass guide as a single unit in the direction of the arrow (5) shown in the figure.
- Remove the rear door quarter glass and rear door quarter glass guide as a single unit in the direction of the arrow (6) shown in the figure.
- Pull the rear door quarter glass guide in the direction of the arrow (7) and remove the rear door quarter glass.
- Install in the reverse order of removal.