With Manual Air Conditioner System: Inspection
- Switch the ignition ON.
- Verify that the rear window defroster switch LED illuminates using the rear window defroster switch.
- Verify that the heated outer mirrors and rear window defroster warm up.
- If the heated outer mirror and rear defroster do not warm up, perform an inspection of each related part.
Inspection of rear window defroster control signal reception condition for front body control module (FBCM)
- Use the front body control module (FBCM) PID/data monitor inspection DEFOG_R_CS to inspect the rear window defroster control signal reception condition. (Refer to PID/DATA MONITOR INSPECTION [FRONT BODY CONTROL MODULE (FBCM)]
.) (Refer to PID/DATA MONITOR TABLE [FRONT BODY CONTROL MODULE (FBCM)]
.)
Rear window defroster relay ON/OFF control inspection
- Measure the terminal voltage at the front body control module (FBCM) terminal 1P. (Refer to FRONT BODY CONTROL MODULE (FBCM) INSPECTION
.)
Rear window defroster relay inspection
- Inspect the rear window defroster relay. (Refer to RELAY INSPECTION
.)
Rear window defroster inspection
- Inspect the rear window defroster. (Refer to REAR WINDOW DEFROSTER INSPECTION .)
Heated outer mirror inspection
- Inspect the heated outer mirrors. (Refer to OUTER MIRROR GLASS INSPECTION .)
- Use the front body control module (FBCM) PID/data monitor inspection DEFOG_R_CS to inspect the rear window defroster control signal reception condition. (Refer to PID/DATA MONITOR INSPECTION [FRONT BODY CONTROL MODULE (FBCM)]
.) (Refer to PID/DATA MONITOR TABLE [FRONT BODY CONTROL MODULE (FBCM)]
.)
- If the heated outer mirror and rear defroster do not warm up, perform an inspection of each related part.