DTC P0722-00: Open Circuit In Output Shaft Speed Sensor Circuit: Notes

DTC P0722:00	Open circuit in output shaft speed sensor circuit
DETECTION CONDITION	Under the following conditions, the output shaft speed sensor signal is not input for 1 s : Engine is running. Vehicle speed signal related DTC is not recorded. Vehicle speed is 16 km/h {9.9 mph} or more . There is no difference between vehicle speed signal from DSC HU/CM and output shaft speed sensor signal. DTC U0121:00 is not recorded. Diagnostic support note The check engine light illuminates if the TCM detects the above malfunction condition during the first drive cycle. The automatic transaxle warning light illuminates if the TCM detects the above malfunction condition during the first drive cycle. PENDING CODE is available. FREEZE FRAME DATA is available. DTC is stored in the TCM memory.
FAIL-SAFE FUNCTION	Inhibits learning control. Inhibits manual mode. Inhibits neutral idle control. Inhibits AAS.
POSSIBLE CAUSE	Output shaft speed sensor malfunction
SYSTEM WIRING DIAGRAM	Not applicable