LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2016 >> CX-5 Touring, AWD >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Fuel Pump Control Module Removal/Installation
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Fuel Pump Control Module Removal/Installation

  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
  2. Tip the rear seat (LH).
  3. Disconnect the clip connected to trunk board.
  4. Disconnect the fuel pump control module connector.
  5. Remove the fuel pump control module.
    Fig 1: Identifying Fuel Pump Control Module With Nuts
    G10916383Courtesy of MAZDA MOTORS CORP.
  6. Install the fuel pump control module using the following procedure.
    1. Insert the bracket tabs into the installation holes in the order shown in the figure.
      Fig 2: Inserting Bracket Tabs Into Installation Holes
      G10916384Courtesy of MAZDA MOTORS CORP.
    2. Temporarily tighten bolt A.
    3. Temporarily tighten bolt B.
    4. Tighten bolts A and B to the specified torque.

      Tightening torque 

      • 8-11 N.m {82-112 kgf.cm, 71-97 in.lbf}
  7. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals