Adjusting Shim Assembly Note
WARNING: This page is about a different variant/trim than selected.
- Assemble the differential carrier to the SSTs.
- Assemble the spacer to the differential carrier.
- Using a vernier caliper and straight edge, measure the height of the rear differential component. This is dimension A.
- Measure the width of the installed differential in the differential carrier with the spacer installed. This is value B.
- The combined thickness of the left and right adjusting shims is obtained by the following formula.
C2 = B - A + 0.110 mm {0.00433 in} C2 = B - A + 0.200 mm {0.00787 in}
- If the combined thickness of the previously installed adjusting shims is between C1 and C2, use the shims as they are.
- If the combined thickness of the previously installed adjusting shims is not between C1 and C2, or if the adjusting shims have to be replaced, select two appropriate adjusting shims from the table below.