Details On DTCs
U2035-87: (VCM) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
360°view monitor control module/parking assist unit (optical) calibration data not received |
| Detection condition |
Determination conditions |
- The vehicle control module (VCM) detects that the 360°view monitor control module/parking assist unit (optical) cannot receive the calibration data from the vehicle control module (VCM).
|
| Preconditions |
|
| Malfunction determination period |
|
| Fail-safe |
(See DTC TABLE [VCM]
.) |
| Vehicle status when DTCs are output |
|
| Possible cause |
NOTE:
- Depending on the module, after the ignition is switched ON (engine off or on) or off/main power is switched ON (READY off or on) or OFF, there is a module that needs 30 s to correctly write the calibration data and configuration data.
- Calibration error
- Internal malfunction related DTCs are stored in the following modules.
- Vehicle control module (VCM)
- Body control module (BCM)
- DTCs are stored in the 360°view monitor control module/parking assist unit (optical).
- Communication error in CAN communication circuit between vehicle control module (VCM) and 360° view monitor control module/parking assist unit (optical)
- 360°view monitor control module/parking assist unit (optical) malfunction
- Vehicle control module (VCM) malfunction (built into body control module (BCM))
|