Diagnostic Procedure

POWER WINDOW SYSTEM DOES NOT OPERATE DURING IG OFF TIMER DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	VERIFY ALL SYSTEM DTCs Perform the DTC inspection. (See DTC INSPECTION .) Are any DTCs displayed?	Yes	Repair or replace the malfunctioning location according to the applicable DTC troubleshooting.
1		No	Go to the next step.
2	INSPECT DOOR LATCH AND LOCK ACTUATOR FOR MALFUNCTION Inspect the applicable part. (Refer to FRONT DOOR LATCH AND LOCK ACTUATOR INSPECTION in service information.) (Refer to REAR DOOR LATCH AND LOCK ACTUATOR INSPECTION in service information.) Is the part normal?	Yes	Go to the next step.
2		No	Repair or replace the malfunctioning location and perform the repair completion verification 1. (Refer to FRONT DOOR LATCH AND LOCK ACTUATOR REMOVAL/INSTALLATION in service information.) (Refer to REAR DOOR LATCH AND LOCK ACTUATOR REMOVAL/INSTALLATION in service information.)
Repair completion verification 1	VERIFY THAT VEHICLE IS REPAIRED Install/connect the part removed/disconnected during the troubleshooting procedure. Has the malfunction symptom been eliminated?	Yes	Complete the symptom troubleshooting. (Explain contents of repair to customer)
Repair completion verification 1		No	Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error. (See MALFUNCTION DIAGNOSIS FLOW [CONTROLLER AREA NETWORK (CAN)] .) If the CAN communication is normal, perform the diagnosis from Step 1.