LF Control Unit Inspection: Notes

Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
Remove the front side trim. (See LF CONTROL UNIT REMOVAL/INSTALLATION .)
Connect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (See TERMINAL VOLTAGE TABLE (REFERENCE) .).
- If the voltage is not as specified in the terminal voltage table (See TERMINAL VOLTAGE TABLE (REFERENCE) .), inspect the parts under Inspection item(s).
  - If the system does not work normally even though the inspection items are normal, replace the LF control unit. (See LF CONTROL UNIT REMOVAL/INSTALLATION .)