LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mercedes Benz >> 1985 >> 190E Standard >> Repair and Diagnosis >> Engine Performance >> System >> Fuel Injection System - BOSCH Cis-E >> Testing - MERCEDES-BENZ >> Electrical Components >> Lambda Control
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Lambda Control

  1. Connect BOSCH LAMBDA CONTROL TESTER (KDJE-P600) to vehicle. Unplug O2 sensor. Run engine until operating temperature is reached. Read and record voltage on tester with engine idling. Reconnect O2 sensor. Push 12-volt button on tester.
  2. Set engine speed to 2000 RPM. If engine is at operating temperature, voltage reading should continuously change. Reading should not vary from previously recorded voltage by more than .8 volts. If reading is correct, lambda control is working and test is complete.
  3. If reading is constant instead of varying, replace O2 sensor or repair wiring to sensor. If reading is higher than 4.8 volts or lower than 2.1 volts, adjust lambda control.
scientia non olet · About LEMON Manuals