LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mercedes Benz >> 2010 >> SLK300 Automatic >> Repair and Diagnosis >> General Information >> Reset Procedures >> ATEQ TPMS Reset Procedure >> ATEQ TPMS Reset Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

ATEQ TPMS Reset Procedure

  1. Using the Tire and Loading Information placard on the driver's door B-pillar or the supplemental tire inflation pressure information on the inside of the fuel filler flap, make sure the tire inflation pressure of all four tires is correct.
  2. Switch ON the ignition.
  3. Press left or right button on left side of the multifunction steering wheel repeatedly until the standard display appears in the multifunction display.
  4. Press up or down button repeatedly until you see the current inflation pressures for each tire appear in the display or the following message appears in the multifunction display: TIRE PRESSURE DISPLAYED AFTER DRIVING FOR A FEW MINUTES.
  5. Press the reset button. The following message will appear in the multifunction display: RESTART TIRE PRESSURE MONITOR?
  6. If you wish to confirm: Press + button. The following message will appear in the multifunction display: TIRE PRESSURE MONITOR RESTARTED.

After driving a few minutes the system verifies that the current tire inflation pressures are within the system's specified range. Afterwards the current tire inflation pressures are accepted as reference values and then monitored.

NOTE: When the wheel positions have been changed, the inflation pressure of a tire may be displayed for the wrong position temporarily. After driving for a few minutes, the inflation pressure will be shown for the correct position.
scientia non olet · About LEMON Manuals