Service Campaign 2015090006 - Update Transmission Control Module Software (2015090006)

WARNING: This page is about the CLS400 4Matic, which is a different variant/trim than selected.

Publication date: 2015-10-09
Reference number: 2015090006

SERVICE CAMPAIGN 2015090006 - UPDATE TRANSMISSION CONTROL MODULE SOFTWARE

SERVICE CAMPAIGN BULLETIN

Reference Number(s): 2015090006, Date of Issue: October 2015

MERCEDES-BENZ:

Model 218, Model Year 2015

SUBJECT

Model 218, Model Year 2015

Update Transmission Control Module Software

This Service Campaign has been initiated because Daimler AG (DAG), the manufacturer of Mercedes-Benz vehicles, has determined that on the subject vehicles, the transmission control module software does not correspond to the current series production configuration. An authorized Mercedes-Benz dealer will update the transmission control module software at the next workshop visit.

Prior to performing this Service Campaign:

Please check VMI to determine if the vehicle is involved in the Campaign and if it has been previously repaired.
Please review the entire Service Campaign bulletin and follow the repair procedure exactly as described.

Approximately 115 vehicles are affected.

PROCEDURE

NOTE:

Use DAS/Xentry 09-10-11/15 with all associated patches or higher.
Follow the steps exactly as described in DAS/Xentry.
Connect battery charger (battery voltage >12.5V).
Ensure all electrical consumers are switched-off.
In the event of software/SCN update issues, contact Star Diagnosis User Help Desk. Please refer to the "pre-call" check list before contacting UHD
Refer to Star Diagnosis System (SDS) Best Practices Guide.

Update fully integrated transmission control module (VGSNAG3) software:
Quick test view -> VGS -> Transmission control for 9-speed transmission (Y3/8n4) -> Adaptations -> Control unit update -> Update of control unit software.
Follow on-screen instructions.

WARRANTY INFORMATION

Operation:

Connect/disconnect battery charger (02-5058).
Star Diagnosis System (SDS), Connect/disconnect (02-4762).
Update fully integrated transmission control module software (02-9304).

WARRANTY INFORMATION

Damage Code	Operation Number	Labor Time (hrs.)
54 985 48 8	02-5058	0.1
	02-4762	0.1
	02-9304	0.1

NOTE: Operation Number labor times are subject to change.