Service Campaign 2015100004 - Update Software For Fuel System Control Module (2015100004)

WARNING: This page is about the S550 4Matic, 2D Coupe, which is a different variant/trim than selected.

Publication date: 2015-11-06
Reference number: 2015100004

SERVICE CAMPAIGN 2015100004 - UPDATE SOFTWARE FOR FUEL SYSTEM CONTROL MODULE

SERVICE CAMPAIGN BULLETIN

Reference Number(s): 2015100004, Date of Issue: November 2015

MERCEDES-BENZ:

Model 222 (S-Class) Hybrid, Model 2015

SUBJECT

Model 222 (S-Class) Hybrid, Model 2015

Update Software for Fuel System Control Module

This Recall Campaign has been initiated because Daimler AG (DAG), the manufacturer of Mercedes-Benz vehicles, has determined that on certain S-Class Hybrid vehicles (222 platform), the synchronization between the fuel pump and the fuel system control module might be compromised after driving in the electric mode. As a consequence, the fuel pressure becomes too low and the combustion engine cannot be restarted. This power loss results in a stall of the vehicle. To correct this condition, an authorized Mercedes-Benz Dealer will update the fuel system control module software on the affected vehicles.

Prior to performing this Recall Campaign:

Please check VMI to determine if the vehicle is involved in the Campaign and if it has been previously repaired.
Please review the entire Recall Campaign bulletin and follow the repair procedure exactly as described.

Please note that Recall Campaigns do not expire and may also be performed on a vehicle with a vehicle status indicator.

Approximately 4 vehicles are involved.

PROCEDURE

NOTE:

Use DAS/Xentry 09-10-11/15 with all associated patches or higher.
Follow the steps exactly as described in DAS/Xentry.
Connect battery charger (battery voltage >12.5V).
Ensure all electrical consumers are switched-off.
In the event of software/SCN update issues, contact Star Diagnosis User Help Desk. Please refer to the "pre-call" check list before contacting UHD
Refer to Star Diagnosis System (SDS) Best Practices Guide.
1. Update engine control module software:
  Control unit view → Type of drive → FSCU → fuel pump → Control unit adaptations → Control unit update → Update of control unit software.
2. Follow on-screen instructions.

NOTE: The following allowable labor operation should be used when submitting a warranty claim for this repair:

WARRANTY INFORMATION

Operation:

Connect/disconnect battery charger (02-5058)
Star Diagnosis System (SDS), Connect/disconnect (02-4762)
Update fuel system control module (02-9334).

WARRANTY INFORMATION

Damage Code	Operation Number	Labor Time (hrs.)
47 902 34 8	02-5058	0.1
	02-4762	0.1
	02-9334	0.1

NOTE: Operation Number labor times are subject to change.