Remove/install starter - AR15.30-P-7100LFA
ENGINE 276.8 in MODEL 217, 222
| Remove/install | |||
| 1 | Detach ground line from battery | AR54.10-P-0003LF | |
| 2 | Remove lower engine compartment paneling | AR61.20-P-1105LF | |
| 3 | Detach steering shaft | Engine 276.8 in model 217, 222 Model 222 up to 4/29/14 with engine 276.8 |
AR46.10-P-8000RK |
| Model 217 with engine 276.8 Model 222 as of 4/30/14 with engine 276.8 |
AR46.10-P-8000-01LW | ||
| Fig 2 | |||
| 4 | Remove catalytic converter | Engine 276.8 in model 217, 222 with code M005 (4MATIC) | AR49.10-P-7100LF |
| 5 | Remove heat shield (1) | ||
| 6 | Detach wiring harness on starter (M1) | AR15.30-P-7100-03LFA | |
| *BA15.30-P-1002-01J | |||
| *BA15.30-P-1001-01J | |||
| 7 | Remove screw/bolts (4) and remove starter (M1) from bottom | *BA15.30-P-1003-01J | |
| Check | |||
| 8 | Check ring gear at the drive plate for wear and damage | When replacing the starter (M1). If complaint present ↓ Replace drive plate |
AR03.30-P-8001LFA |
| 9 | Install in the reverse order |
STARTER
| Number | Designation | Engine 276 | |
|---|---|---|---|
| BA15.30-P-1001-01J | Nut, connection for terminal designation 30 | Nm | 15 |
STARTER
| Number | Designation | Engine 276 | |
|---|---|---|---|
| BA15.30-P-1002-01J | Nut, connection for terminal designation 50 | Nm | 6 |
STARTER
| Number | Designation | Engine 276 | |
|---|---|---|---|
| BA15.30-P-1003-01J | Bolt, starter to crankcase | Nm | 40 |