Check Wires Between ABS Control Module & Hydraulic Solenoid Relay
- With ignition switch in OFF position, connect breakout box with adapter to ABS control module connector. Leave ABS control module disconnected. Disconnect hydraulic actuator assembly connector.
- Measure resistance of Brown wire between breakout box pin No. 28 and hydraulic actuator assembly connector. Measure resistance of Green/Yellow wire between breakout box pin No. 35 and hydraulic actuator assembly connector. If resistances are less than 5 ohms, go to PINPOINT TEST D12 . If resistances are more than 5 ohms, service wire(s) in question.