Brake Switch (Cruise Control): Service and Repair

REMOVAL







1. Remove the deactivator switch.
1 Disconnect the electrical connector.
2 Rotate counterclockwise 45 degrees and remove the deactivator switch.

INSTALLATION

All vehicles







1. Release the plunger lock (if equipped).
^ Turn the lock knob counterclockwise until first click is felt.

2. Fully depress the brake pedal.







3. Install the deactivator switch.
1 Position the deactivator switch in the bracket and rotate clockwise 45 degrees.
2 Connect the electrical connector.

Vehicles equipped with locking tab
4. Slowly release the brake pedal and tug moderately once the pedal reaches the rest position.

NOTE: There should be an extra click heard when tugging on the brake pedal.