Stripped Nut, Restraints Control Module (RCM) and Side Sensor

1. Remove the component from where the weld nut is to be repaired.
2. Inspect the weld nut and surrounding area for repair.
^ If there is not enough clearance for a larger bolt stud to go through or a larger bolt head to turn, then a threaded insert will have to be installed. Follow the instructions with the thread insert repair kit.
3. If a 6 mm weld nut is stripped, drill out the hole using a letter "H" or 0.26 in (6.5 mm) drill bit. Then tap, using an 8 mm by 1.25 bit.
^ Do not oversize a 6 mm weld nut by more than 8 mm.
4. If an 8 mm weld nut is stripped, drill the hole using a letter "R" or 0.3990 in (9.75 mm) drill bit. Then tap, using a 10 mm by 1.50 bit.
^ Do not oversize an 8 mm weld nut by more than 10 mm.
5. Obtain the appropriate oversized screw.
6. Install the attaching screw(s) to the component.
7. Tighten the attaching screws to specification.