Remote Transmitter Programming

NOTE: All remote transmitters are programmable and must be set at the same time.

NOTE: Programming (or reprogramming) of the remote transmitters can be accomplished using a diagnostic tool or by carrying out the following steps:

Turn the key from OFF to RUN four times within three seconds, ending in RUN. The locks will then lock and unlock, confirming program mode has been entered.
Press any button on each remote transmitter to be programmed. The doors will lock and unlock to confirm that each remote transmitter has been programmed.
If additional remote transmitters are to be programmed, repeat Step 3 within 7.5 seconds or Steps 2 and 3 if more than 7.5 seconds have elapsed.
To exit program mode, wait at least 20 seconds.

NOTE: Failure to wait at least 20 seconds will cause programming failures.

Wait at least 20 seconds after turning the key to OFF or after the last remote transmitter has been programmed to activate a remote transmitter for testing and verification.