LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mercury >> 2009 >> Milan Base, 3.0 1, AWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System - Vehicle Dynamic Systems >> Removal And Installation >> Stability Control Sensor Cluster >> Removal And Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal And Installation

NOTE: When installing a new stability control sensor cluster, it must be calibrated to the ABS module. Follow the scan tool directions for the calibration procedures.
  1. Remove the instrument panel lower center finish panel. Refer to INSTRUMENT PANEL FINISH PANEL - CENTER .
  2. Disconnect the stability control sensor cluster electrical connector.
  3. Remove the 2 stability control sensor cluster bracket bolts and the stability control sensor cluster.
    • To install, tighten to 8 Nm (71 lb-in).
  4. To install, reverse the removal procedure.
    • Using the scan tool, calibrate the new stability control sensor cluster to the ABS module. Follow the scan tool directions for Interactive Vehicle Dynamics (IVD) Initialization.
scientia non olet · About LEMON Manuals