Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

Detach the finish panel.

Fig 1: Finish Panel

Courtesy of FORD MOTOR CO.

Disconnect the electrical connector.

Fig 2: Finish Panel Electrical Connector

Courtesy of FORD MOTOR CO.

Remove the 4 heating ventilation air conditioning (HVAC) module screws and pull the HVAC module away from the instrument panel.

Fig 3: Climate Control Assembly Screws

Courtesy of FORD MOTOR CO.

Remove the screw and position the in-vehicle temperature sensor to access the electrical connector.

Fig 4: In-Vehicle Temperature Sensor & Screw

Courtesy of FORD MOTOR CO.

Disconnect the connector.

Fig 5: In-Vehicle Temperature Sensor Connector

Courtesy of FORD MOTOR CO.

Disconnect the aspirator hose and remove the in-vehicle temperature sensor.

Fig 6: In-Vehicle Temperature Sensor & Aspirator Hose

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.