61 00 ... Notes on handling optical fibers
WARNING: This page is about a different car, the 2005 BMW 545i and 2004 BMW 545i. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
To avoid damage when handling optical fibers, comply with the following points:
- The minimum permitted bending radius is 25 mm.
- Do not subject optical fibers to compressive and tensile load.
- Protect optical fibers against the effects of heat >/= 85° C (e.g. during welding work, drying work with infrared heater or hot air blower).
- Optical fibers are permitted to show only one junction point (bridge), replace optical fibers if necessary.
NOTE:
The optical fibers are colored differently as follows:
- Green =MOST (M edia O riented S ystems T ransport) optical fibers
- Yellow =ISIS (I ntelligent S afety and I ntegration S ystem) optical fibers
- Orange = repair optical fibers.