Diagnostic Procedure

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

STEP 1. Scan tool CAN bus diagnostics
Using scan tool MB991958, diagnose the CAN bus lines.

Q: Is the check result normal?

YES : Go to Step 2.

NO : Repair the CAN bus lines. (Refer to TROUBLESHOOTING .)
STEP 2. Scan tool diagnostic trouble code
Check the TC-SST diagnostic trouble code. (Refer to TROUBLESHOOTING .)

Q: Is the DTC set?

YES : Perform the relevant troubleshooting.

NO : Go to Step 3.
STEP 3. Scan tool service data
Item No. 17: T/M shift range (Refer to DATA LIST REFERENCE TABLE .)

Q: Is the check result normal?

YES : Intermittent malfunction. (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION .)

NO : Go to Step 4.
STEP 4. Check whether the DTC is reset.
Q: Is DTC No. U1425 set?

YES : Replace the AWC-ECU.(Refer to AWC-ECU .) Then go to Step 5.

NO : Intermittent malfunction. (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION .)
STEP 5. Check whether the DTC is reset.
Q: Is DTC No. U1425 set?

YES : Return to Step 1.

NO : This diagnosis is complete.