< Except Vehicles With Steering Wheel Voice Control Switch >

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Check the resistance and continuity between the AWC switch connector terminals.

RESISTANCE SPECIFICATION

AWC selection switch terminal No.	AWC selection switch	Resistance value
2 - 4	(-)	Approximately 270 Ω
	(+)	Approximately 2.1 kΩ
	OFF	Approximately 71 kΩ

Fig 1: Checking Resistance And Continuity Between AWC Switch Connector Terminals

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

CONTINUITY SPECIFICATION

Terminal No.	Probe (Tester: Ω range)	Continuity
1	-	Present
5	+	Present
1	+	No
5	-	No

When other than above, replace the AWC switch.