Special Tools

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

SPECIAL TOOLS SPECIFICATION

Tool	Tool number and name	Supersession	Application
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.	MB990767 Front hub and flange yoke holder	MB990767-01	Fixing of the hub
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.	MB991618 Hub bolt remover	General service tool	Removal of the hub bolt
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.	MB991897 or MB992011 Ball joint remover	MB991113-01, MB990635-01 or General service tool	Ball joint disconnection NOTE: Steering linkage puller (MB990635 or MB991113)is also used to disconnect knuckle and tie rod end ball joint.
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.	MB990241 Axle shaft puller MB990242 Puller shaft MB990244 Puller bar	MB990241-01 or General service tool	Removal of the driveshaft Removal of hub assembly
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.	MB991354 Puller body	General service tool	Removal of the driveshaft Removal of hub assembly
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.	MB991721 Slide hammer	-	Removal of the output shaft
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.	MB991017 MB990998 MB991000 A, B: Front hub remover and installer C: Spacer	MB990998-01	Provisional holding of the wheel bearing Measurement of hub starting torque Measurement of wheel bearing end play NOTE: MB991000, which belongs to MB990998, should be used as a spacer.
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.	MB990685 Torque wrench	General service tool	Measurement of hub starting torque
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.	MB990326 Preload socket	General service tool	Measurement of hub starting torque
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.	MB991561 Boot band crimping tool	MB991561	EBJ boot (resin boot) band installation