A: Engine Assembly/Engine Mounting Bracket Installation

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Set special tool MB991454 and a chain block to the engine assembly.
Install the engine assembly, being careful not to pinch the cables, hoses or wiring harness connectors.
Place a garage jack against the engine oil pan with a piece of wood in between, and install the engine mounting bracket while adjusting the position of the engine.
Remove the chain block.

Fig 1: Holding Engine Assembly With Chain Block
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Install special tool MB991928 or MB991895 which is used during installation of transaxle assembly to hold the engine assembly. (Refer to TRANSAXLE ASSEMBLY < M/T >), (Refer to TRANSAXLE ASSEMBLY < TC-SST >)

Fig 2: Identifying Special Tool MB991928 Or MB991895
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 3: Identifying Special Tool MB992201 Or MB991895
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.