Service Specifications
WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
STANDARD VALUE SPECIFICATION
| Item | Standard value | Limit | |
|---|---|---|---|
| Drive belt tension | Vibration frequency Hz (Reference) | 98 - 124 | - |
| Tension N (lb) (Reference) | 248 - 400 (56 - 90) | - | |
| Valve clearance (at cold) mm (in) | Intake valve | 0.20 ± 0.03 (0.008 ± 0.0012) | - |
| Exhaust valve | 0.03 ± 0.03 (0.012 ± 0.0012) | - | |
| Basic ignition timing at idle | 5°BTDC ± 3° | - | |
| Actual ignition timing at curb idle | Approximately 10° BTDC | - | |
| CO contents % | 0.5 or less | - | |
| HC contents ppm | 100 or less | - | |
| Curb idle speed r/min | 700 ± 100 | - | |
| Compression pressure (200 r/min) kPa (psi) | 1,090 (158) | Minimum 650 (95) | |
| Compression pressure difference of all cylinder kPa (psi) | - | 100 (14) | |
| Intake manifold vacuum at curb idle kPa (in Hg) | - | Minimum 60 (18) | |