B: Engine And Transaxle Assembly Holding

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Install a special tool for holding the engine and transaxle assembly.

< Engine hanger MB991928 is used >
1. Assemble the engine hanger (special tool MB991928). Set the following parts on the base hanger.
  - Slide bracket (HI)
  - Foot x 4 (standard) (MB991932)
  - Joint x 2 (140) (MB991931)
2. Set the foot of the special tool as shown in the figure.
  NOTE: Slide the slide bracket (HI) to adjust the engine hanger balance.
  
  Fig 1: Locating Slide Bracket And Engine Hanger Balance
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
3. Mount special tool MB991454 to the power steering oil pump bracket and the engine hanger, and set it to special tool MB991928 to support the engine and transaxle assembly.
  
  Fig 2: Locating Power Steering Oil Pump Bracket And Special Tool MB991928
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  
  Fig 3: Identifying Special Tool MB991928 Or MB991895
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
< Engine hanger MB991895 is used >
1. Set the foot of special tool MB991895 as shown in the figure.
  NOTE: Slide the foot to adjust the engine hanger balance.
  
  Fig 4: Locating Slide Bracket And Engine Hanger Balance
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. Mount special tool MB991454 to the power steering oil pump bracket and the engine hanger, and set it to special tool MB991895 to support the engine and transaxle assembly.
  
  Fig 5: Locating Power Steering Oil Pump Bracket And Special Tool MB991928
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  
  Fig 6: Identifying Special Tool MB991928 Or MB991895
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.