Brake Pedal Distortion Check

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Place the brake pedal assembly on a level surface as shown in the figure, and set the distance from the center of the pin assembly mounting hole to the level surface to 97 mm (3.82 inch). Make sure that the dimension A in the figure (distance from the pedal pad center part to the level surface) is within the standard value.
Standard value (A):

240 - 246 mm (9.4 - 9.7) < M/T >

242 - 248 mm (9.5 - 9.8) < TC-SST >

Fig 1: Identifying Distance From Pedal Pad Center Part To Level Surface
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
When dimension A is not within the standard value, replace the brake pedal assembly.