Hub Bolt Replacement

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Required Special Tools:

MB990767: Front Hub and Flange Yoke Holder
MB991618: Hub Bolt Remover

Remove the front caliper assembly and front disk brake, and retain the front caliper assembly with a wire and the like to prevent from falling (Refer to FRONT AXLE HUB ASSEMBLY ).
Use special tool MB991618 to remove the hub bolts.

Fig 1: Identifying Hub Bolts With Special Tool (MB991618)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Install the plain washer to the new hub bolt, and install the bolt with a nut while holding the hub with special tool MB990767.

Fig 2: Holding Hub With Special Tool (MB990767)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Install the front brake disk and the front caliper assembly (Refer to FRONT AXLE HUB ASSEMBLY ).