Input Check

Input checks are to be made when the speed control system cannot be set and when it is necessary to check whether input signals are normal.

1. Connect an analog voltmeter between ground and diagnostic connector Light Green wire. start engine. Turn on set switch with resume switch held on. The input check codes should now display.
   CAUTION: The system cannot be set during input check display.
2. Perform each input procedure as outlined in table. SeeFig 1 . Each code will be displayed in order of priority, beginning with No. 1. SeeFig 2 . If no display is present, a possible malfunction may be present in the power supply circuit or the set and resume switch.

Fig 1: Input Check Display Patterns

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Input Check Procedures

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.