LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 1990 >> Eclipse Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests - PFI >> Ignition System >> TDC Sensor (SOHC Engines) >> Test No. 2
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test No. 2

  1. Turn ignition on. Check for battery voltage on distributor connector terminal as specified in CRANK ANGLE & TDC SENSOR SUPPLY WIRE TERMINAL IDENTIFICATION (SOHC)  table. See Figure and Figure .
  2. If battery voltage is not present, repair supply wire between ignition switch and distributor connector. If battery voltage is present, connect one lead of ohmmeter to ground and go to step 3).
  3. Connect other ohmmeter lead to distributor connector terminal as specified in CRANK ANGLE & TDC SENSOR GROUND WIRE TERMINAL IDENTIFICATION (SOHC)  table.
  4. If there is continuity, go to step 5). If there is no continuity, repair ground wire between distributor connector and ECU.
  5. Check pin condition of distributor connector. If necessary, repair pin connections. If pin condition is okay, remove distributor. If necessary, repair pin connections. If connector is okay, replace crank angle and TDC sensor assembly.
scientia non olet · About LEMON Manuals