DTC U1415: Variant coding not completed: Diagnosis

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Required Special Tools:

MB991958 Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: Vehicle Communication Interface (V.C.I.)
- MB991827 M.U.T.-III USB Cable
- MB991910 M.U.T.-III Main Harness A

STEP 1. Using scan tool MB991958, diagnose the CAN bus lines.
Using scan tool MB991958, diagnose the CAN bus lines.

Q: Is the check result normal?

YES : Go to Step 2.

NO : Repair the CAN bus lines. (Refer to TROUBLESHOOTING .) After repairing the CAN bus line, go to Step 5.
STEP 2. Scan tool diagnostic trouble code for other systems
Use scan tool to check that the diagnostic trouble code B222C is set in the ETACS-ECU.

Q: Is any DTC set?

YES : Perform troubleshooting for the diagnostic trouble code that is set. Then go to Step 4.

NO : Go to Step 3.
STEP 3. Check for diagnostic trouble codes of other systems
Q: Is DTC U1417 set?

YES : Perform the troubleshooting for diagnostic trouble code No. U1417.(Refer to DTC U1417: VARIANT CODING VALUE INVALID (INCLUDES FAULTY INSTALLATION) .)

NO : Go to Step 4.
STEP 4. Check whether the DTC is reset.
1. Ignition switch "LOCK" (OFF)
2. Ignition switch "ON"
3. Check that the ABS warning light is extinguished.
Q: Is DTC U1415 set?

YES : Replace the hydraulic unit (incorporates in ASC-ECU).(Refer to HYDRAULIC UNIT .) Then go to Step 5.

NO : Intermittent malfunction. (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION .)
STEP 5. Check whether the DTC is reset.
1. Ignition switch "LOCK" (OFF)
2. Ignition switch "ON"
3. Check that the ABS warning light is extinguished.
Q: Is DTC U1415 set?

YES : Return to Step 1.

NO : The procedure is complete.