Entering On-Board Diagnostics (Using DRB-II): Notes

1. Before entering on-board diagnostics, refer to PRETEST INSPECTION . Turn ignition off. Attach Mitsubishi Motors Corporation (MMC) cartridge to DRB-II. Connect DRB-II to diagnostic connector. Diagnostic connector is located next to junction block, above left kick panel. See Figure.
2. Ensure all accessories are off. Turn ignition on. All character positions will illuminate and copyright information will appear on screen for a few seconds. Display will then change to DRB-II menu.
3. If DRB-II displays an error message, refer to DRB-II ERROR SCREENS . The following DRB-II modes can be accessed from DRB-II menu: VEHICLES TESTED, HOW TO USE, CONFIGURE and SELECT SYSTEM.