Test No. 10 (Throttle Position Sensor & Idle Switch Circuit)
- When checking idle switch, if accelerator pedal is pressed, battery voltage should be present on terminal No. 4 of control unit. When accelerator pedal is released, battery voltage should not be present on terminal No. 4 of control unit.
- When checking throttle position sensor, if throttle valve is in idle position, .45-.55 volts (.48-.72 volts on Stealth and 3000GT) should be present on terminal No. 5 of control unit.
- When throttle valve is in wide open throttle position, 4.5-5.5 volts should be present on terminal No. 5 of control unit. If circuit does not test correctly, replace switch or repair harness.