LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 1992 >> Eclipse Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 1.8L >> Self-Diagnostic Tests >> Test NS-5A - Repairing Fuel System
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test NS-5A - Repairing Fuel System

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For appropriate wiring diagram, see WIRING DIAGRAMS .
  1. Turn ignition on. Using DRB-II, actuate fuel pump. With MPI control relay connected, measure voltage on MPI control relay connector terminal No. 2 (Black/Green wire). If voltage is less than 10 volts, go to next step. If voltage is more than 10 volts, repair open circuit in Black/Green wire between MPI control relay and ECU 18-pin connector terminal No. 13, and perform TEST VER-1  .
  2. With MPI control relay connected, measure voltage on MPI control relay connector terminal No. 7 (White/Red wire). If voltage is less than 10 volts, go to next step. If voltage is more than 10 volts, go to step 4).
  3. With MPI control relay connected, measure voltage on MPI control relay connector terminal No. 3 (Black/White wire). If voltage is more than 10 volts, replace MPI control relay, and perform TEST VER-1  . If voltage is less than 10 volts, repair open circuit in Black/White wire between MPI control relay connector and ignition switch splice, and perform TEST VER-1  .
  4. Turn ignition off. Disconnect ECU 18-pin connector. Measure resistance of White/Red wire between MPI control relay connector terminal No. 7 and ECU 18-pin connector terminal No. 56. If resistance is more than 10 ohms, repair open circuit in White/Red wire, and perform TEST VER-1  . If resistance is less than 10 ohms, replace ECU, and perform TEST VER-1  .
scientia non olet · About LEMON Manuals