Transaxle Oil Level Check

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Remove the engine room under cover front B assembly. (Refer to UNDER COVER .)
Remove the oil filler plug and gasket.

Fig 1: Identifying Oil Filler Plug, Oil Drain Plug And Centermember
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Check that the oil level is just below the lower edge of the oil filler plug hole.
Check that the oil is not excessively foul and has moderate viscosity.
Install the oil filler plug and new gasket, then tighten them to the specified torque.
Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb)
Install the engine room under cover front B assembly. (Refer to UNDER COVER .)

Fig 2: Identifying Filler Plug Hole, Gasket And Oil Filler Plug
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.