LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 1993 >> Montero Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Diagnostic Tests >> Code 36: Ignition Timing Adjustment Signal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Code 36: Ignition Timing Adjustment Signal

NOTE: For component terminal identification, see TERMINAL IDENTIFICATION  . For wiring diagrams, see WIRING DIAGRAMS article in this section.

Turn ignition switch to ON position. Using DVOM, check voltage at ignition timing adjustment terminal (located at firewall) with terminal grounded and ungrounded. With terminal grounded, voltage should be 0-1.0 volt. With terminal ungrounded, voltage should be 4.0-5.5 volts. If voltage is not as specified, repair ignition timing adjustment terminal wiring harness or connector as necessary. If voltage is as specified, replace ECM.

scientia non olet · About LEMON Manuals