LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 1994 >> Eclipse Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Engine Controls - Tests W/Codes) >> Diagnostic Tests >> Code 61: Transaxle Control Module Signal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Code 61: Transaxle Control Module Signal

WARNING: This page is about a different car, the 1994 Mitsubishi Diamante. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For component terminal identification, see TERMINAL IDENTIFICATION  . For wiring diagrams, see WIRING DIAGRAMS article in the ENGINE PERFORMANCE Section.
  1. Disconnect Transaxle Control Module (TCM) and ECM connectors. Ground TCM connector terminal No. 7. Using DVOM, check continuity between chassis ground and ECM connector terminal No. 116. If continuity does not exist, repair wiring harness as necessary. If continuity exists, go to next step.
  2. Ground TCM connector terminal No. 9. Check continuity between chassis ground and ECM connector terminal No. 59. If continuity does not exist, repair wiring harness as necessary. If continuity exists, go to next step.
  3. Ground TCM connector terminal No. 108. Check continuity between chassis ground and ECM connector terminal No. 7. If continuity does not exist, repair wiring harness as necessary. If continuity exists, test is complete. Intermittent problem may exist. See TESTS W/O CODES article in the ENGINE PERFORMANCE Section.
scientia non olet · About LEMON Manuals