LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 1994 >> Precis Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Diagnostic Tests >> Code 41 - Fuel Injector Failure >> Harness Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Harness Inspection

  1. Measure injector power supply voltage. Disconnect injector harness connectors. Turn ignition on. Using DVOM, measure voltage at each injector harness connector terminal No. 1 (Black/Red wire) on Sonata V6, No. 2 (Red wire) on Sonata 4-Cylinder, No. 2 (Green/White wire) on all other models. If voltage measured is less than battery voltage, inspect and repair circuit(s) as needed.
  2. Check continuity of injector ground circuit. Disconnect ECM harness connector. Ensure ignition is off. Connect a jumper wire between each injector ECM terminal and ground. Disconnect injector harness connectors. Using ohmmeter, check continuity between each injector terminal and vehicle ground. See FUEL INJECTOR GROUND CIRCUIT IDENTIFICATION  table for ECM terminal numbers and wire colors.
    FUEL INJECTOR GROUND CIRCUIT IDENTIFICATION

    Injector No. Wire Color Corresponding (1) ECM Terminal No.
    1 Yellow 13
    2 Yellow/Black 26
    3 Lt. Green/Black 12
    4 Lt. Green/White 25
    (1)
    Use 26-pin connector. See Figure , Figure and Figure for terminal identification.
scientia non olet · About LEMON Manuals